4 Replacement Procedure 4.21 RGB HARNESS
4-52 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)
Installing the RGB HARNESS
To install the RGB HARNESS, follow the steps below and refer to Figure 4-29.
1. Set the RGB HARNESS in the slot in place and secure it with the following screws.
• #4-40×5C UNIFIED screw ×2
2. Connect the RGB HARNESS to the connector CN9510 on the system board.
3. Fix the RGB HARNESS to the DC FAN with the INSU RGB HNS.
To Next Page
Loading...
