4.23 Sound/USB board and MIC HARNESS 4 Replacement Procedure
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-59
Installing the Sound/USB board and MIC HARNESS (Internal microphone)
To install the Sound/USB board and MIC HARNESS, follow the steps below and refer to
Figure 4-34.
1. Set the MIC HARNESS to the slot in place.
2. Set the Sound/USB board in place and secure it with the following screw.
• M2.0×4B BIND screw ×1
3. Connect the SOUND/USB HARNESS, speaker harness and MIC HARNESS to
the connector CN9820, CN6180 and CN6050 on the Sound/USB board.
4. Connect the SOUND/USB HARNESS to the connector CN9520 on the system board.
To Next Page
Loading...
