4 Replacement Procedure 4.26 LCD COVER ASSY
4-66 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)
Installing the LCD COVER ASSY
To install the LCD COVER ASSY, follow the steps below and refer to Figure 4-38.
1. Place the COVER ASSY on the flat desk.
2. Set the LCD COVER ASSY on the COVER ASSY in place.
3. Secure the GND SPG FIN, BH L ASSY and BH R ASSY to the COVER ASSY
with the following screws.
• M2.5×6C TAPPING Screw × 2 (1 each)
To Next Page
Loading...
