4 Replacement Procedure 4.29 LCD unit
4. Set the LCD COV CAP L and LCD COV CAP R while engaging the latches.
CAUTION: Make sure that harnesses are not pinched.
5. Secure the LCD COV CAP L and LCD COV CAP R with the following screws.
• M2.0×8C OTHER screw ×2 (1 each)
6. Stick two MASK SEALs (silver) on the LCD COV CAP L and LCD COV CAP R.
7. Set the LCD MASK ASSY on the LCD COVER ASSY and secure it with following
crews.
• M2.5×4C FLAT HEAD screw ×6 (upper ×4, bottom 2 )
8. Stick four LCD CUSHONs and two MASK SEALs (black) on the LCD mask.
4-78 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)
To Next Page
Loading...
