4.31 Hinge 4 Replacement Procedure
Installing the Hinge
To install the hinge, follow the steps below and refer to Figure 4-54.
CAUTION: Before setting the hinge, apply LOCTITE 425 to the bosses shown in the
figure below.
1. Set the hinges (BH L ASSY/BH R ASSY) on the LCD COVER ASSY in place and
secure them with the following screws.
• M2.5×4B S-THIN HEAD ×4 (2 each)
CAUTION: When replacing to new hinges, stick new SQUARE CUSHIONs (L1,M1) to
the hinges in the places as shown below.
SQUARE
CUSHION (L1)
SQUARE
CUSHION (L1)
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-85
To Next Page
Loading...
