Toshiba TECRA R10 - Page 37

1.9 Power Supply 1 Hardware Overview
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 1-23
Table 1-6 Power supply output rating (1/3)
On/Off of a power supply system and a power supply system in each State is as follows.
AMT non-support mode
ACPI State S0 S0 S3 S3 S4/S5 S4/S5 G3
Wake On LAN Support
not
support
Support
not
support
Support
not
support
P System Power supply
○ ○ - - - - -
B System Power supply
○ ○ ○ ○ - - -
LAN Power supply
○ ○ ○ - ○ - -
M System Power supply
○ ○ - - - - -
E System Power supply
○ ○ ○ ○ ○ * -
S System Power supply
○ ○ ○ ○ ○ ○ -
RTC Power supply
○ ○ ○ ○ ○ ○ ○
AMT support model
（At the time of Moff, it is the same as that of not supporting AMT）
ACPI State S0 S0 S3/S4/S5 S3 S3 S4/S5 S4/S5
G
3
M State M0 M0 M1 Moff Moff Moff Moff
Wake On LAN Support
not
support
Setup is
i
mpossible.
Support
not
support
Support
not
support
P System Power supply
○ ○ - - - - - -
B System Power supply
○ ○ ○ ○ ○ - - -
LAN Power supply
○ ○ ○ ○ - ○ - -
M System Power supply
○ ○ ○ - - - - -
E System Power supply
○ ○ ○ ○ ○ ○ * -
S System Power supply
○ ○ ○ ○ ○ ○ ○ -
RTC Power supply
○ ○ ○ ○ ○ ○ ○ ○
○：On
－：Off
*: It is dependent on support of Wake On LAN.