Toshiba TOSVERT VF-AS1 - Page 118

E6581528
E-45
5
690V-50Hz default setting(=)
Setting  tocauses default value is to be set for 690V-50Hz.
When  to be set after setting default value is to be set for 690V-50Hz (same value as )
Setting  tocauses all the following parameters to be changed from factory shipment (setting)
• Base frequency 1  : 50Hz • RP/high-speed pulse input point 2 frequency  : 50Hz
• Base frequency voltage 1  : 690V • Automatic light-load high-speed operation frequency  : 50Hz
.• Upper limit frequency  : 50Hz • Commercial power/inverter switching frequency  : 50Hz
• VI/II input point 2 frequency  : 50Hz • PID deviation upper limit  : 50Hz
• RR/S4 input point 2 frequency  : 50Hz • PID deviation lower limit  : 50Hz
• Base frequency 2  : 50Hz • Process upper limit  : 50Hz
• Base frequency voltage 2  : 690V • PID output upper limit  : 50Hz
• Base frequency 3  : 50Hz • Forward speed limit input level  : 50Hz
• Base frequency voltage 2  : 690V • Reverse speed limit input level  : 50Hz
• Base frequency 4  : 50Hz • Undervoltage detection level  : 59%
• Base frequency voltage 4  : 690V • Overvoltage limit operation level  :113%
• RX input point 2 frequency  : 50Hz • Regenerative power ride-through control level: 75%
• AI1 input point 2 frequency  : 50Hz • Point 2 frequency  : 50Hz
• AI2 input point 2 frequency  : 50Hz