Toshiba TOSVERT VF-AS1 - Acceleration;Deceleration 2; Setting Acceleration;Deceleration Patterns and Switching Acceleration;Deceleration

E6581528
F-48
6
6.30 Acceleration/deceleration 2
6.30.1 Setting acceleration/deceleration patterns and switching
acceleration/deceleration patterns 1, 2, 3 and 4
 : Acceleration time 2
 : Deceleration time 2
 : Acceleration/deceleration 1 pattern
 : Acceleration/deceleration 2 pattern
 : Panel acceleration/deceleration selection
 : Acceleration/deceleration switching frequency 1
 : Acceleration S-pattern lower limit adjustment
 : Acceleration S-pattern upper limit adjustment
 : Deceleration S-pattern lower limit adjustment
 : Deceleration S-pattern upper limit adjustment
 : Acceleration time 3
 : Deceleration time 3
 : Acceleration/deceleration 3 pattern
 : Acceleration/deceleration switching frequency 2
 : Acceleration time 4
 : Deceleration time 4
 : Acceleration/deceleration 4 pattern
 : Acceleration/deceleration switching frequency 3
•Function
Four acceleration times and four deceleration times can be specified individually. The selection/switching
mode can be selected from the following 3 options:
1) Selection by means of parameters
2) Switching by means of frequencies
3) Switching by means of terminals
[Parameter setting]
Title Function Adjustment range Default setting
 Acceleration time 2 [Note]~ sec. According to model
 Deceleration time 2 [Note]~ sec. According to model

Panel acceleration/deceleration
selection
:Acceleration/deceleration 1
: Acceleration/deceleration 2
: Acceleration/deceleration 3
: Acceleration/deceleration 4

 Acceleration time 3 [Note]~ sec. According to model
 Deceleration time 3 [Note]~ sec. According to model
 Acceleration time 4 [Note]~ sec. According to model
 Deceleration time 4 [Note]~ sec. According to model
Note: The minimum setting of acceleration and deceleration times have been set respectively at 0.1 sec. by default,
but they can be changed within a range of 0.01 sec. (setting range:0.01~600.0 sec.) by changing the setting
of the parameter  (default setting).
⇒ For details, refer to Section 5.20.
1) Selection using parameters
Time [s]
Output frequency [Hz]









0
Time [s]
Time [s]
Time [s]
=

=


=


=

Acceleration/deceleration time 1 is initially set as the default. Acceleration/deceleration time 2, 3 and 4can be
selected by changing the setting of the .
Enabled if = (operation panel input enabled).