E6581528
F-68
6
6.35.2 Setting of optional meter outputs
~ , ~ : Meter output settings
⇒ For details, refer to Instruction Manual (E6581341) specified in Section 6.42.
6.35.3 Calibration of analog outputs
: FM voltage/current output switching
, : FM output gradient characteristic and bias adjustment
, : AM output gradient characteristic and bias adjustment
•Function
Output signals from FM/AM terminals are analog voltage signals. Their standard setting range is from 0 to
10Vdc.
The output current from terminal FM can be changed to 0 to 20mAdc (or 4 to 20mAdc) by changing the settings
of terminal SW2 and a parameter.
[Parameter setting]
Title Function Adjustment range Default setting
FM voltage/current output
switching
: Voltage 0~10V output
: Current 0~20mA output
FM output gradient
characteristic
: Negative gradient
(descending)
: Positive gradient (ascending)
FM bias adjustment -～. %
AM output gradient
characteristic
: Negative gradient
(descending)
: Positive gradient (ascending)
AM bias adjustment -～. %
Note: To switch to 0-20mAdc (4-20mAdc), set to .
FM terminals setting example
SW2=OFF, = = (%) SW2=OFF, = = (%)
20
0
0
Internal calculated value
100%
0
Internal calculated value
100%
4
Output current
(mA)
20
Output current
(mA)
SW2=OFF= = = (%)
SW2=OFF
=
=
=
(%)
20
0
0
Internal calculated value
100%
0 100%
: Large gain
:Small gain
4
Output current
(mA)
20
Output current
(mA)
Internal calculated value
The analog output inclination can be adjusted using the parameter
For code data 50 to 64, negative inclination is invalid.
To Next Page
Loading...
