Toshiba TOSVERT VF-AS1 - Open Network Option; My Function

E6581528
F-83
6
Title Function Adjustment range Default setting
 Block read data 1
:Deselect
:Status information
:Output frequency
:Output current
:Output voltage
:Alarm information
:PID feedback value
:Input terminal board monitor
:Output terminal board monitor
:VI/II terminal board monitor
:RR/S4 terminal board monitor
:RX terminal board monitor
:Input voltage (DC detection)
:Speed feedback frequency
:Torque
:MY monitor 1
:MY monitor 2
:MY monitor 3
:MY monitor 4
:Free notes

 Block read data 2 Ditto 
 Block read data 3 Ditto 
 Block read data 4 Ditto 
 Block read data 5 Ditto 
 Free notes ~ 
* : No action ... No action is taken even if a timeout occurs.
Alarm ......... An alarm goes off if a timeout occurs.
The message “” blinks at the left end of the operation panel.
Trip ............ The inverter trips when a communication time-over occurs.
The message “” blinks on the operation panel.
Note: Changes to the parameters , and  do not take effect until the power is turned off and
then on again.
6.39.2 Open network option
 ~  : Communication option settings 1 to 7
 ~  : Communication option settings 8 to 13
 : Disconnection detection extended time
 : Inverter operation at disconnection
 : Preset speed operation selection
 ,  : Selection of monitoring
⇒ For details, refer to Instruction Manual (E6581281, E6581343) specified in Section 6.42.
6.40 My function
 : Input function target 11~  : My function selection
⇒ For details, refer to Instruction Manual (E6581335) specified in Section 6.42.