99
TP-LINK(config)# ip address 192.168.0.69 255.255.255.0
ip management-vlan
Description
The ip management-vlan command is used to configure the management
VLAN,
through which you can log on to the switch.
Syntax
ip management-vlan {vlan-id}
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode
Example
Set the VLAN6 as management VLAN:
TP-LINK(config)# ip management-vlan 6
ip dhcp-alloc
Description
The ip dhcp-alloc command is used to enable the DHCP Client function. When
this function is enabled, the switch will obtain IP from DHCP Client server.
Syntax
ip dhcp-alloc
Command Mode
Global Configuration Mode
Example
Enable the DHCP Client function:
TP-LINK(config)# ip dhcp-alloc
ip bootp-alloc
Description
The ip bootp-alloc command is used to obtain IP address from BOOTP Server.
To Next Page
Loading...
