TP-Link JetStream L2 Lite TL-SG3210 - Cluster

176
Configure the owner of entry 1 as owner1:
TP-LINK(config)# snmp-rmon alarm owner 1 owner1
snmp-rmon alarm enable
Description
The snmp-rmon alarm enable command is used to enable SNMP-RMON
Alarm Management entry. To disable the corresponding entry, please use no
snmp-rmon alarm enable command.
Syntax
snmp-rmon alarm enable {index}
no snmp-rmon alarm enable {index}
Parameter
index —— The index number of the entry desired to enable, ranging from 1 to
12, in the format of 1-3,5.
Command Mode
Global Configuration Mode
Example
Enable the Alarm Management entries 1,2,3,4 and 8:
TP-LINK(config)# snmp-rmon alarm enable 1-4,8
show snmp global-config
Description
The show snmp global-config command is used to display SNMP
configuration globally.
Syntax
show snmp global-config
Command Mode
Any Configuration Mode
Example
Display SNMP configuration globally:
TP-LINK> show snmp global-config