TP-Link JetStream L2 Lite TL-SG3210 - Show Storm-Control Ethernet; Show Port Rate-Limit

115
Syntax
show interface counters { ethernet [interface] }
Parameter
Interface ——The port selected to display the statistic information. By default,
the statistic information of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the statistic information of Ethernet port3:
TP-LINK(config)# show interface counters ethernet 3
show storm-control ethernet
Description
The show storm-control ethernet command is used to display the
storm-control information of an Ethernet port.
Syntax
show storm-control ethernet [port]
Parameter
port —— The port-number of the port selected to display the storm-control
information. It ranges from 1 to 10. By default, the storm-control information of
all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the storm-control information of all Ethernet ports:
TP-LINK(config)# show storm-control ethernet
show port rate-limit
Description
The show port rate-limit command is used to display the rate-limit information
of an Ethernet port.
Syntax
show port rate-limit [interface-num]