TP-Link JetStream L2 Lite TL-SG3210 - Lacp Port-Priority; Show Lacp Interface

39
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the admin key of port 1 as 1024:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# lacp admin-key 1024
lacp port-priority
Description
The lacp port-priority command is used to set the port priority for a port. To
restore to the default priority, please use no lacp port-priority command.
Syntax
lacp port-priority value
no lacp port-priority
Parameter
value —— System priority, ranging from 0 to 65535. By default, the value is
32768.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Set the system priority of port 1 to1024:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# lacp port-priority 1024
show lacp interface
Description
The show lacp interface command is used to display the port configuration
information of LACP.
Syntax
show lacp interface [ethernet port-num]