TP-Link TL-SG2428P - Adding the Port to the Specified VLAN

Configuring 802.1Q VLAN 802.1Q VLAN Configuration
User Guide 141
VLAN Name Status Ports
------- -------- --------- ---------
2 RD active
Switch(config-vlan)#end
Switch#copy running-config startup-config
2.2.2 Adding the Port to the Specified VLAN
Follow these steps to add the port to the specified VLAN:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list |
port-channel port-channel-id | range port-channel port-channel-list }
Enter interface configuration mode.
Step 3 switchport general allowed vlan vlan-list { tagged | untagged }
Add ports to the specified VLAN.
vlan-list: Specify the ID or ID list of the VLAN(s) that the port will be added to. The ID ranges
from 1 to 4094.
tagged | untagged: Select the egress rule for the port.
Step 4 show interface switchport [fastEthernet port | gigabitEthernet port | ten-gigabitEthernet
port | port-channel lag-id ]
Verify the information of the port.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to add the port 1/0/5 to VLAN 2, and specify its egress
rule as tagged:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/5
Switch(config-if)#switchport general allowed vlan 2 tagged
Switch(config-if)#show interface switchport gigabitEthernet 1/0/5
Port Gi1/0/5:
PVID: 2