User Guide 506
Configuring ARP ARP Configurations
Figure 2-4 Configuring Proxy ARP
Select the desired interface and enable proxy ARP. Then click Apply.
IP Address Displays the IP address of the Layer 3 interface
Subnet Mask Displays the subnet mask of the IP address.
Status Enable proxy ARP feature on the interface. The interface will respond the ARP request
sender with its own MAC address.
2.1.5 Configuring Local Proxy ARP
Local Proxy ARP is used in the situation that two devices are in the same VLAN but isolated
on the layer 2 ports.
Choose the menu L3 FEATURES > ARP > Proxy ARP > Local Proxy ARP to load the
following page.
Figure 2-5 Configuring Local Proxy ARP
Select the desired interface and enable local proxy ARP. Then click Apply.
IP Address Displays the IP address of the Layer 3 interface
Subnet Mask Displays the subnet mask of the IP address.
Status Enable local proxy ARP feature on the interface. The interface will respond the ARP
request sender with its own MAC address.
To Next Page
Loading...
