CG-SVX17D-EN 127
Controls Interface
• USB 2.0 or higher
• Pentium II, III or higher processor
• 128Mb RAM minimum for TechView, 1G recommended for total Windows system
• 1024 x 768 resolution of display
• CD-ROM (optional for copying TechView install to CD)
• 56K modem (optional for internet connection)
• 9-pin RS-232 serial connection (optional for connection to DynaView)
Note: TechView was designed for the preceding listed laptop configuration. Any variation will
have unknown results. Therefore, support for TechView is limited to only those operating
systems that meet the specific configuration listed here. Only computers with a Pentium II
class processor or better are supported; Intel Celeron, AMD, or Cyrix processors have not
been tested.
TechView is also used to perform any CH530 service or maintenance function. Servicing a CH530
main processor includes:
• Updating main processor software
• Monitoring chiller operation
• Viewing and resetting chiller diagnostics
• Low Level Intelligent Device (LLID) replacement and binding
• Main processor replacement and configuration modifications
• Setpoint modifications
• Service overrides
Software Download
Instructions for First Time TechView Users
This information can also be found at http://www.trane.com/Commercial/DesignAnalysis/
TechView.aspx.
1. Create a folder titled CH530 (C:\CH530) on your hard drive. This \CH530 folder is the standard
location for the installation file. Storing the installation file in this location helps you remember
where it is stored and makes it easier for technical support personnel to assist you.
2. Click the Download link for the latest version on the TechView Software Download page. The
File Download - Security Warning dialog box appears.
3. Click Save to copy the installation file to your hard drive. Specify the \CH530 folder you created
in Step 1 on the Save dialog box.
4. Double-click the installation (.exe) file. The License Agreement dialog box appears.
5. Click I Agree after reviewing the License Agreement. The Choose Componenets dialog box
appears. All components are selected by default. (These are the actual MP versions for all units.)
Deselect any components you do not want included in the installation.
Note: Deselecting components reduces the size of the installed application.
6. Click Install. The installation dialog appears with a progress meter indicating the percentage
of the installation that has occurred. An installation information file appears when the
installation is complete.
7. C l i c k Close to exit the installation routine.
To Next Page
Loading...
