78 CG-SVX17D-EN
Installation - Electrical
Installer-Supplied Components
Customer wiring interface connections are shown in the electrical schematics and connection
diagrams that are shipped with the unit. The installer must provide the following components if not
ordered with the unit:
• Power supply wiring (in conduit) for all field-wired connections.
• All control (interconnecting) wiring (in conduit) for field supplied devices.
• Circuit breakers.
Power Supply Wiring
WARNING
Proper Field Wiring and Grounding Required!
All field wiring MUST be performed by qualified personnel. Improperly installed and grounded
field wiring poses FIRE and ELECTROCUTION hazards. To avoid these hazards, you MUST follow
requirements for field wiring installation and grounding as described in NEC and your local/
state electrical codes. Failure to follow codes could result in death or serious injury.
All power supply wiring must be sized and selected accordingly by the project engineer in
accordance with NEC Table 310-16.
To Next Page
Loading...
