INSTRUCTION MANUAL
UG30 CONTROL
mP30-UG30 - Rev. 1.5 - Date: 18-03-2004 EN
3 (44)
CONTENTS
Page
Program identification 4
Warnings 4
General characteristics 5
Lay-out of Uniguard Base UG30/mP30 circuit 6
Inputs and outputs 7
Optional sensors 8
Optional circuits 8
Lay-out of CP1 circuit 9
Display 16
Keyboard 17
Information on display when unit is OFF 18
Unit start-up conditions 19
Switching the unit ON and OFF 19
STATUS MASK 20
Information on display when unit is ON 20
Unit status display 21
Access to parameters when consulting or programming 22
Changing the Password 27
Hardware configuration 28
Operation hour-counter 29
Exceeding hour-counter threshold 30
Maintaining the humidifier cylinder
30
Remote control of unit
Connecting more than one unit
31
32
Temperature set points 33
Humidity set points 34
Calibration and setting
34
Clock/dater – Time-bands 35
Delays due to alarm signals
35
Serious alarms 35
Active alarms 35
Reading the alarms historic record 36
Alarm codes description 40
Default values 43
Memory reset 44
Appendix:
Flowchart for UG30/mP30 masks – Access with USER password
44
Flowchart for UG30/mP30 masks – Access with FACTORY password
To Next Page
Loading...
Need help?
General
