INSTRUCTION MANUAL
UG30 CONTROL
34 (44)
mP30-UG30 - Rev. 1.5 - Date: 18-03-2004 EN
CLOCK/DATER – TIME BANDS (with optional clock circuit only)
SETTING THE DATE AND TIME
To modify date and time, you have to input the “USER” password to access the parameters of the “Clock” menu in
programming mode.
(press for
5 seconds)
0
uP
….
**
uP
2
.
°C
%rH
53
**: input the “USER” password contained in
the envelope enclosed with the manual.
…. ….
Prob
Cloc
2
10:39
2
10:39
….
2
10:54
SETTING THE TIME-BANDS
If using controls with an optional clock circuit fitted, you can set the automatic start-up and stop of the unit on a time
basis (time-bands) obtaining up to 2 daily ON-OFF cycles.
N.B.: The ON status from time-bands operates only if the unit is activated from the keyboard and from a remote
input.
Enabling of time-bands is through the following parameter:
Cloc
Minimum Maximum
Default
rt
0= time-band disabled
2= ON/OFF from time-bands
0 2 0
To Next Page
Loading...
Need help?
General
