To Next PageTo Next PageWhat to do if Trane Odyssey Air Conditioner exceeded limit of equipment pairings?
The Trane Air Conditioner app has a limit of 10 saved pairings per device. On Android devices, the oldest pairing will be automatically deleted when the limit is reached. If auto-delete fails, you'll need to manually delete pairings. iOS users must manually delete pairings through the device settings.
What to do if Trane Odyssey Air Conditioner device is outside of Bluetooth range limits?
Bluetooth connectivity has range limitations. If you move too far away from the Trane Air Conditioner controller, you will lose the connection. To reconnect, you'll need to re-access connectivity from the Units List page.
Why my smart device is unpaired or disconnected from Trane Odyssey controller?
Your smart device may be unpaired or disconnected from the Trane Air Conditioner controller if: * You pressed the Bluetooth button on the controller while connected. * The controller's power was cycled, a firmware update was performed, or the controller was restored/started. * The equipment was shut down.
How to meet smart device requirements for Trane Odyssey?
To meet the smart device requirements for the Trane Air Conditioner, you need: * Apple iPhone (iOS V10; iPhone 6 or later). * Android (V5.0 Lollipop or later; a device with Bluetooth V4.2 or later). Note: It is not possible to check what Bluetooth connectivity version is installed on an Android device, as it does not appear in Settings.
General| Efficiency | Up to 18 SEER |
|---|---|
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Sound Level | As low as 72 dB |
| Product Type | Air Conditioner |
| Series | Odyssey |
| Warranty | 10-year limited warranty on compressor |
| Condenser Coil | Spine Fin™ |
General advisories on hazards, cautions, and notices for safe operation of the equipment.
Guidelines on responsible handling of refrigerants and environmental concerns related to ozone layer.
Requirements for personal protective equipment during installation and servicing to prevent injury.
Details on thermostat control wire, zone sensor wire, and shielded twisted pair cable specifications.
Introduction to pairing condensers with Symbio air handlers and model number descriptions.
Detailed wiring and configuration for various condenser-air handler combinations.
Guide to downloading, installing, and using the Symbio Service & Installation mobile app.
Explains the controller's LCD display, keypad, and menu structure for operation.
Steps to adjust equipment settings via the mobile app or onboard display for proper operation.
Procedures for service tests, viewing alarms, and resolving common operational issues.
Contact details and resources for further assistance and technical support.
