25
22.10.2021
TNX65/42
Preparing to transport a machine with milling unit
Connecting bar
Cover
Remove the tool chain and chain magazine (only with optional
120 positions)
The chain magazine must be partly dismantled in order to transport the
TNX 65/42 with milling unit and tool magazine with 120 positions.
The tool chain must be brought into a defined position before it is
disconnected.
Risk of injury!
The machine must be switched off and secured to prevent
re-activation before starting any assembly / disassembly work.
The upper part of the tool magazine must be lifted off with the aid of a crane or
fork lift truck.
Requirements to be met by a fork lift truck
Min. lifting height mm 3500
Min. fork length mm 1000
Max. fork width mm 150
Forks adjustable to a minimum distance of mm 114
Disassembly
• Remove the connecting bar between the chain magazine and the
machine.
• Remove the cover over the chain magazine.
To Next Page