Traub TNX65 - Page 4

4
22.10.2021
TNX65/42
Table of contents
Preparing to transport a machine with milling unit Preparing to transport a machine with milling unit .................................................................... .................................................................... 23 23
Transport retainers ............................................................................................................................. 23
Position of the transport retainers ................................................................................................. 23
Remove the tool chain and chain magazine (only with optional 120 positions) ................................. 25
Remove the cover on the milling unit with tool changer ................................................................... 26
Separate the chain of the chain magazine (only with optional 120 positions) ................................... 27
Remove upper part of chain magazine .......................................................................................... 28
Transporting the machine Transporting the machine ............................................................................................................... ............................................................................................................... 29 29
Delivery of the machine ..................................................................................................................... 29
Transport by crane (min. load capacity 12 t) ....................................................................................... 30
Set of hoisting gear and fittings ..................................................................................................... 31
TNX 65/42 Centres of gravity (machine with control cabinet) ................................................... 32
Transport by fork lift truck .................................................................................................................. 33
Transport by truck .............................................................................................................................. 34
Installing the machine Installing the machine ..................................................................................................................... ..................................................................................................................... 35 35
Installing the machine by crane ......................................................................................................... 35
Positioning and installing the machine with transport rollers ............................................................ 36
Lifting the machine with hydraulic jacks ....................................................................................... 37
Positioning the transport rollers .................................................................................................... 37
Rough alignment of the machine ...................................................................................................... 37
Set up control cabinet on wheels ...................................................................................................... 38
Remove transport retainers from the control cabinet ................................................................... 38
Aligning the wheels on the control cabinet ................................................................................... 39
Indicator lamp .................................................................................................................................... 39
Remove transport retainers from the machine ................................................................................. 40
Working area door ..................................................................................................................... 40
Workpiece handling with remnant removal device ................................................................... 40
Transport retainer for turret (tool carrier / main spindle and opposed spindle / milling unit) .......... 41
Installation of the milling unit components Installation of the milling unit components ................................................................................. ................................................................................. 45 45
Installation of the tool chain and chain magazine (only with optional 120 positions) ......................... 45
Install upper part of chain magazine .............................................................................................. 45
Connect the chain of the chain magazine (only with optional 120 positions) .................................... 47
Install cover on milling unit with tool changer ................................................................................... 49
Fuels Fuels .................................................................................................................................................. .................................................................................................................................................. 51 51
Overview of fuels .............................................................................................................................. 51