8. Pass the front derailleur cable through the
threaded bolt in the junction box, and fully seat the
housing end in the end of the barrel adjuster bolt.
9. Pass the rear derailleur cable through the bottom
hole in the junction box and fully seat the housing
end in the housing stop.
10. Pass the cables through the bottom bracket. Do not
cross the cables.
11. Place tape on the end of each cable, and mark them
front or rear.
6
INSTALLING THE CONTROL CENTER (MECHANICAL)
12. Use tape to hold the bottom bracket cable guide in
place while you slide the cables from the bottom
bracket to the corresponding derailleurs.
13. Slide the tube over the cable and through the
frame until it contacts the plastic bottom bracket
cable guide. Install the black grommet over the
top end of the guide tube
18
To Next Page
Loading...
