Goblin – Operational Manual
TRINITY
[35]
Select Goblin(Prog) in list box and click OK that will open the page such as shown
below.
By default the cursor will blink in password box which shows user will enter
password and enter the password used in meter and then, click to enter into
Programming Mode. After configuring each programmable parameter, click
to confirm the setting. If user selelcts Installation type and CT Ratio, the unit may
restart. User will wait till the unit enters into Run Mode and then user will again enter
password. In case, a message displays “Error In USB Communication” click OK and
try again so that all the programmable parameter can be configured.
To Next Page
Loading...
Need help?
General
