Samba
20
Cleaning the inlet filter
It is recommended that the filter is periodically
cleaned in order to maintain the performance of
the shower. It is essential that this operation is
carried out by a competent person.
IMPORTANT: Before servicing, switch off the
electricity supply at the mains.
Remove the cover. The inlet filter is situated in
the inlet pipe, which is part of the solenoid valve
(fig.39).
To access the filter, remove the trimplate then
disconnect and remove the compression fitting.
Also, depending on the incoming pipework
arrangements, if there is not enough slack in the
pipework, it could mean the removing the unit
from the wall.
When cleaning the filter, DO NOT use a sharp
object, as it will cause damage. It is preferable to
use an old toothbrush or similar.
To Next Page
Loading...
