Triton Samba User Manual

OPERATING THE SHOWER
IMPORTANT: Make sure the commissioning
procedure has been carried out.
To start the shower
Turning the power selector to the red or blue
symbol positions will start water to flow.
To stop the shower
Switch the power selector to the ‘STOP’
position and water will cease to flow.
To use the power selector
The power selector has four positions − stop,
cold, economy and high − as shown (fig.20).
STOP is to switch off the electric and water
supply at the shower – no flow or power is
used.
Blue symbol is cold water only. Adjusting the
temperature control at this setting will only
alter the force of the water from the sprayhead.
IT WILL NOT ALTER THE WATER TEMPERATURE.
Single red symbol is an economy setting
for using less power during warmer months.
Temperature adjustment at this setting is via
the temperature control.
Note: If the stated flow rate required for the
unit cannot be met due to low water pressure,
it will be necessary to operate the unit on this
setting during the warmer months because of
flow rate limitations entering the unit.
Double red symbol is a high setting which
allows the highest flow achievable for your
preferred temperature. This setting should
normally be regarded as optimum shower
performance throughout the year. Temperature
adjustment at this setting is via the temperature
control.
Samba
14
Power selector
Stop
Economy
High
Temperature
control
Cold
Fig.20
WARNING!
If restarting immediately after
stopping, be aware that a slug of
hot water will be expelled for the
first few seconds.

Triton Samba Specifications

General

Brand	Triton
Model	Samba
Category	Bathroom Fixtures
Language	English