Triton T100XR User Manual

23
CLEANING THE FILTER
It is recommended that the filter is periodically
cleaned in order to maintain the performance of
the shower. It is essential that this operation is
carried out by a competent person.
• SWITCH OFF the electricity and water supply
at the mains.
• The inlet filter is situated in the side of the
inlet pipe (g.22).
• To gain access to the filter, remove the
trimplate and then unscrew the retaining nut
from the side of the inlet pipe.
• When cleaning the filter, DO NOT use a sharp
object as it will cause damage. It is preferable
to use an old toothbrush or similar.
• To reassemble, follow the procedure in
reverse.
• DO NOT over tighten the fittings on
reassembly.
Instructions for installers and service engineers only
INSTRUCTIONS FOR INSTALLERS AND SERVICE ENGINEERS ONLY
Instructions for installers and service engineers only
Fig.22

Triton T100XR Specifications

General

Type	Electric Shower
Finish	White
Cable Entry Points	Back, Bottom Right
Installation	Wall-mounted
Water Entry Points	Back, Bottom Right