33
General Information
Maximum Speed
The maximum speed achieved per lap and
the lap number.
Average Speed
The average speed per lap and the lap
number.
Distance Travelled
The distance travelled per lap and the lap
number.
Turning the Lap Timer On or Off
To switch the lap timer on or off, with the
motorcycle stationary and in neutral turn the
ignition to the ON position.
Press and release button 'A' until set up is
visible in the display screen. Then press
button 'B'.
Press and release button 'A' until Lap is visible
then press button 'B'. ON or OFF will flash in
the display screen.
Press button 'A' to select the desired display
then press button 'B'. Do not touch buttons
'A' or 'B' until Lap is visible in the display.
Then press and release button 'A' until r
Eturn
is visible then press button 'B'. Trip 1 will be
visible in the display screen.
The lap timer has two modes; data recording
mode and data retrieval mode.
Data Recording Mode
1. L a p d i s p l a y
2. Stop watch icon
3. Lap time
Note:
• The data recording mode and the
data retrieval mode will only
operate when the lap timer (lap) is
turned on.
To select the data recording mode, turn the
ignition to the ON position.
Press and release button 'A' until Lap is visible
in the screen then press button 'B'. L01 and a
stop watch icon will be visible in the
speedometer display, and the lap timer will
be visible in the display screen.
Pressing the starter button (with the engine
running only) will start the lap timer. The
display will show the lap time in minutes,
seconds and hundredths of a second, and the
stop watch icon is on.
To Next Page
Loading...
Need help?
General
