Triumph Speed Triple R User Manual

34
General Information
New Lap Recording
1. Starter button
At the end of the lap, pressing the starter
button again will register the start of a new
lap. The display will show the last lap time for
5 seconds, then the new lap number for
5 seconds. After this time, the speedometer
display will show the current lap number and
the display screen will show the current lap
time.
Data Retrieval Mode
1. Lap number
2. Stop watch icon
3. Lap timer
4. Button A
5. Button B
The data retrieval mode can be accessed in
one of two ways:
• With the ignition in the ON position,
from the lap timer display, press
button 'B'.
• From the Data Recording Mode,
with the engine running and the
motorcycle stationary, press the
starter button for 2 seconds. This will
return the display to the 'Lap'
display. From here press button 'B'.
Note:
• The data retrieval mode cannot be
accessed whilst the motorcycle is
in motion.
ccmh_1
1
1
cfiv_12
3
2
5
4

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres