TrojanTwo User Guide v3.8
4.3 Threading using the currently threaded material
1 Press ‘Reload Web’ button at TrojanTwo\Handling menu.
2 Place the magnet on far side of the splicing table.
Magnet on far side of the spicing station.
3 Cut the material on the diagonal, using a knife. Use the carved cutting path on the splicing table to
ensure a clean, straight cut.
4 Remove the current label roll core from the unwinder.
5 Place the chosen material on the unwinder roll according to chapter 4.1.1.
6 Draw the material up to the splicing table.
Label material drawn up to splicing table from unwinder.
To Next Page
Loading...
