Maintenance
Notice
Please also pay attention to the safety notes in the Safety Notes for Maintenance section and in the
section containing notes on special hazard types.
OPERATING CONDITION
Depending on the type and scope of the maintenance work, the Atmos or the affected area must either be shut down or
completely disconnected from any power.
To perform cleaning and repair work, the Atmos must always be disconnected from the power supply.
Warning
Causes death or life-threatening injuries. The power supply cable to the Atmos must always be
disconnected during cleaning and maintenance work.
CARE AND VISUAL INSPECTION
The operating personnel are tasked with checking the accessible areas of the Atmos for contamination and damages
daily. Contaminations should be removed, if accessible, and damage reported to the appropriate maintenance
personnel.
Notice
Unavoidable dirt deposits can make the markings of control elements or warning signs illegible. This can
lead to faulty operation, which may cause property and consequential damage.
•
Therefore, you should always check the Atmos when you start work.
•
Therefore, you should clean all dust and other contamination off all control elements, displays and warning labels
once a week by wiping them with a damp cloth.
Therefore, you should clean all dust and other contamination off all control elements, displays and warning labels once
a week by wiping them with a damp cloth.
All water-based industrial cleaning agents can be used without restriction.
VISUAL INSPECTION
Type of inspection ✓
Checking the operating
behavior
Observe Atmos for normal operating behavior:
•
Running noises
•
Heating up,
•
Odor development.
In the event of irregular operating behavior, shut down the Atmos if necessary
and inform maintenance personnel immediately.
Check for residues
Check the Atmos and the surrounding area for residues of material and
operating materials and remove them if necessary.
24
To Next Page
Loading...
Need help?
General