Maintenance
3. Open the caps on both sides of the suction unit.
4. Remove the lid and li down the fine filter box of the Atmos by the handles.
5. Place the new fine filter box and lid back on the aspirator and close the caps on
both sides.
6. Connect the suction unit by means of the mains plug and activate the unit.
8.2 Filter calibration
Notice
For optimal operation, we recommend that you calibrate the exhaust system before the first startup. This
ensures optimal operation.
Make sure that:
•
the device is connected to the power grid
•
the exhaust hoses are connected
•
the airflow regulator and the exhaust openings in your laser machine are in the standard position
•
the standard table is inserted and not covered.
Calibration
•
Now turn on your Atmos Pure by pressing the on-off button for longer than 0.5 seconds
•
The two status indicators light up green and the turbines start up.
27