PEX-1000 Series
Print Engine Service Manual
41
10. If this happens, please turn the heater line button in opposite direction. In the previous
case, you may turn clockwise direction. Until you see the even picture I show you.
11. Then after adjusting it, lock the 2 locking screws to fix the heater line position.
Note:
For different thickness label, you may need to print out such pattern to see if this
heater line is fit with this heat line position or not.
If you find that even with the lowest speed and highest density, the density is still
not enough, you can try to do this test to adjust heat line.
To Next Page
Loading...
