REDUCING FIRE RISK
• Remove wire twist-ties from paper or plastic bags used to facilitate cooking in the oven.
• If materials inside the oven ignite, keep the oven door closed, turn the oven off, and disconnect the power
cord or shut off power at the fuse or circuit breaker panel.
• If smoke is observed, switch off or unplug the oven. Keep the door closed to stifle any flames.
• DO NOT use the cook cavity for storage purposes.
• DO NOT overcook food. Carefully attend to the oven if paper, plastic, or other combustible materials are
placed inside the oven to facilitate cooking.
• DO NOT leave paper products, cooking utensils, or food in the cavity when the oven is not in use.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This oven is equipped with a cord that has
a grounding wire with a grounding plug, which must be plugged into an outlet that is properly installed and
grounded. Consult a qualified electrician or serviceman if uncertain about the ability to follow grounding
instructions or if doubt exists as to whether the appliance is properly grounded.
DO NOT use an extension cord. If the power cord is too short, have a qualified electrician or serviceman
install an outlet near the appliance.
WARNING: Improper grounding can result in risk of electric shock.
WARNING: Risk of Electric Shock. If the cord or plug becomes damaged, replace only with a cord
and plug of the same type
POWER CORD REPLACEMENT OR REMOVAL
If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly
qualified person.
WARNING: If the oven is unplugged during service or maintenance, the user must be able to access
and see the plug at all times to ensure that the oven remains unplugged. The plug must remain near the
oven and cannot be placed behind another appliance or in another room.
RF INTERFERENCE CONSIDERATIONS
The Eco oven generates radio frequency signals. This device has been tested and was determined to be
in compliance with applicable portions of FCC part 18 requirements and to the protection requirements
of Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to
electromagnetic compatibility at the time of manufacture. However, some equipment with sensitivity to
signals below these limits may experience interference.
If your equipment experiences interference:
• Increase the physical separation between this oven and the sensitive equipment.
• If the sensitive device can be grounded, do so following accepted grounding practices.
• If battery-powered microphones are being affected, ensure that the batteries are fully charged.
• Keep sensitive equipment on separate electrical circuits if possible.
• Route intercom wires, microphone wires, speaker cables, etc. away from the oven.
SAVE THESE INSTRUCTIONS
ii IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
