TurboChef Eco - TROUBLESHOOTING; Troubleshooting Specific Faults and Blockages

3. Security Type
Ensure the security type is set to WPA2 unless
otherwise instructed by your network administrator.
4. WiFi Password
The WiFi Password is the case sensitive password
needed to join the WiFi network. After touching
the WiFi Password icon, use the on-screen keyboard
to type in the WiFi network password and touch
Enter.
If you are unsure of the WiFi Password for the
network, contact your network administrator. In
some instances, the WiFi Password may be printed
on a label on the bottom of your WiFi router.
NOTE: “Open” or public networks may require
additional authentication. Contact TurboChef
customer support at 800.90TURBO or +1
214.379.6000 for assistance. Coordination with a
network administrator may be required.
5. Channel
The Channel is determined and assigned by the
WiFi router.
NOTE: If you are experiencing difficulty obtaining
or keeping WiFi connectivity, TurboChef
recommends setting the WiFi router’s channel to 1.
Change the network channel by logging into your
router. For help with your WiFi router, contact
your network administrator.
6. MAC IP
The MAC IP is automatically assigned.
7. SAVE Button
After entering or updating any of the settings on the
WiFi Network screen, touch the SAVE button.
Touching the SAVE button will cause the oven to
attempt to connect to the network.
Ensuring Connectivity
When the oven is successfully connected to a
network, the Information screen will indicate the
oven is “connected.” See page 13.
If MAC IP is blank, the oven may not be
configured properly to connect to a WiFi
network. Call TurboChef Customer Support at
800.90TURBO or +1 214.379.6000.
Sound Volume
Touch “Volume” and use the plus or minus icons or
slider to increase or decrease the beep volume.
Set Date
To set or correct the date, touch “Date.” Enter the
date in the following format - MM/DD/YY. Touch
“ENTER” to save the changes.
Set Time
To set the time, touch “Time.” Enter the time
in 24-hour format (8:30 p.m. = 20:30). Touch
“ENTER” to save the changes.
NOTE: The clock will not automatically update for
Daylight Savings Time.
NOTE: The user interface will automatically
convert the time to 12-hour format.
INFO MODE16