Run a Test Cook Cycle
If desired, touch “Cook” to perform a test cook.
NOTE: The oven may require additional warm-up time before a test cook can be performed.
Add/Edit Event Messages
Event messages are alerts that pause a cook cycle and show a message. When cooking, the message will
appear immediately before the event to which the message was applied. For example, a message applied
to event 1 will appear before the cook cycle begins. Event messages must be specified at the time of
manufacture.
When event messages are specified, the Edit Item Screen is modified as shown in figure 69.
Touch the icon beneath the cook settings for the event you want to add a message to and, using the keypad,
input the name and touch “Enter.” Once all changes are made, touch “SAVE.”
NOTE: The field allows for a maximum of 32 characters.
NOTE: Touch the “123” icon to access numbers and symbols.
NOTE: Touch the icon to change case between upper and lower case.
NOTE: Touch the Alt icon to show special characters.
Figure 68: Run a Test Cook Cycle Screen
Figure 69: Item Edit, Event Messages
CANCEL SAVE
COOK
Name Item
Time: 00:35
Time
Air
Microwave
Instructions
Event 1 Event 2 Event 3 Event 4 Event 5 Event 6
70% 30% 0% 0% 0% 0%
80% 80% 10% 10% 10% 10%
10% 10% 10% 10% 10% 10%
EDIT MODE
29
To Next Page
Loading...
