Auto On
“Auto On” is a feature that turns the oven on
automatically at a specific time of day.
1. To set auto-on, ensure the time of day is
accurate (above).
2. Toggle the yes/no icon to the YES position to
enable Auto On.
3. Select the temperature to which the oven will
automatically heat up.
4. Enter the time in 24-hour format (20:30 = 8:30
p.m.). Touch “SAVE” to save all changes.
NOTE: The time will automatically convert to
12-hour format when saved.
Auto Off
“Auto Off” is a feature that turns the oven off
automatically at a specific time of day.
1. To set auto-off time, ensure the time of day is
accurate.
2. Toggle the yes/no icon to the YES position to
enable Auto Off.
3. Enter the time in 24-hour format (20:30 = 8:30
p.m.). Touch “SAVE” to save all changes.
NOTE: The time will automatically convert to
12-hour format when saved.
Service Screen
From the Service screen, view:
• Fault Log
• Counters and Timers
• Test Mode
Fault Log
View the faults by Count or History. Use the toggle
to change between count view and history view.
Faults by Count
Shows the number of faults occurred by fault code.
Press “Reset” to reset all counters to 0 and press the
down arrow to view the rest of the fault codes.
Faults by History
View time stamps of each fault occurrence and the
fault code.
NOTE: If the fault counts are all “0,” exit the Info
Mode and re-enter it to refresh the screen.
Figure 23: Oven Status (Auto On) Screen
1 2 3
4 5 6
7 8 9
0
CANCEL SAVE
Auto On: 2030
Auto O:
Current: OFF
to O
rrent:
F
On
RETURN TO
SETTINGS
Figure 24: Oven Status (Auto Off) Screen
Figure 25: Service Screen
Fault Log
Count History
RETURN TO
SERVICE
F1: Blower Running Status Bad
F2: Cook Temperature Low
F3: Magnetron Current Low
F4: Door Monitor Defective
F5: Magnetron Over Temperature
F6: EC Temperature High
F7: RTD Open
F8: Heat Rise Low
004
008
000
001
004
000
002
000
Figure 26: Faults by Count Screen
Figure 27: Faults by History Screen
INFO MODE
17
To Next Page
Loading...
