154
Mirror Assembly
Ensure the safety precautions listed in the page
127 are followed properly.
Assembly
• Remove the allen screw (2 nos) from the bracket
licence complete using a hexagonal key 5 mm
from the tool kit (ref. page 160) (ref. Fig. 75).
• Assemble the mirror assembly LH to the bracket
licence complete along with grommets (2 nos) on
both sides bracket licence complete.
• Now tighten the allen screw (2 nos) with the
bracket licence complete using a hexagonal key
5 mm from the tool kit (ref. Fig. 76).
Tightening torque 7 ± 1 Nm
• Similarly assemble the mirror assembly RH.
Fig. 75
Fig. 76
To Next Page
Loading...
