158
Restoring the Motorcycle to use
• Take the motorcycle out of garage and clean the
motorcycle thoroughly (ref. page 156).
• Remount the battery after bench charging if
required.
• Fill the engine oil and check the oil level using the
gauge.
• Lubricate the necessary parts.
• Fill up fresh fuel in the fuel tank (ref. page 95).
• Check and inflate the tyre pressure to the
specified limit.
• Check and correct the points mentioned in pre-
ride check (ref. page 102).
Turn on the ignition and start the engine. Allow the to run
in idle mode for few minutes and ride out.
To Next Page
Loading...
