29
29
Switch Assembly RH
Switch assembly RH is located in the handle bar at
RH side and has the following switches in it.
Switch electric starter with Engine Kill switch (ref.
Fig. 16)
This motorcycle is provided with integrated switch
electric starter with engine kill switch.
• The engine kill switch is used to switch off ‘ ’
the engine but to keep other DC system active.
• The ignition circuit is disabled, preventing the
engine from being started. To restart the engine,
return the switch to the ‘ ’ position.
• To start the engine keep the switch in ‘ ’
position, Ensure the transmission is in neutral or
else press the clutch lever before engaging the
starter switch.
Do not operate the kill switch when riding else you may
fall due to rear wheel locking.
This switch is mainly intended for use in emergencies
when you need to stop the engine quickly.
If the electric starter switch is pressed more than 3
seconds continuously, the starter motor gets disabled
automatically and will not crank the engine. The motor
cranks the engine only after 1 second or if the switch is
released and repressed again.
Note
Fig. 16
To Next Page
Loading...
Need help?
General
