Upper limit
Lower limit
J10O510A
The transmission is already lled
with transmission uid properly.
When using a hydraulic imple-
ment, add more fluid for the
amount of the implement.
•
•
NOTE
J10O511A
Transmission
uid drain plug
(2) Changing
①
Unscrew the drain plug on the
lower section of the transmission
to drain contaminated transmis
-
sion uid. As hot uid ows out
of the transmission rst, be care-
ful not to get burnt.
②
After draining fluid, tighten the
transmission uid drain plug.
③
Pour the specified amount of
the specified transmission fluid
through the ller hole.
Do not add fluid over the upper
limit level.
Check the uid before starting the
engine or at least in 5 minutes af-
ter the engine is stopped.
When trying to use new uid from
a different manufacturer or fluid
with different viscosity, drain used
fluid completely before adding
new uid.
This tractor uses transmission u-
id as hydraulic oil.
Therefore, keep the oil change in-
terval.
•
•
•
•
•
NOTE
To Next Page
Loading...
