TYM T1054 - Checking Electric Wiring; Jump Start

5 - 
MAINTENANCE
993F027A
JUMP START
①
Turn off all electric devices.
②
Connect the positive terminal of
the normal battery to the positive
terminal of the discharged bat
-
tery with the jump cable.
③
Connect the negative terminal
of the normal battery to the en
-
gine body of the tractor for the
discharged battery with the jump
cable.
►
④
Firstly, start the engine of the ve
-
hicle with the normal battery.
Then, start the engine of the trac-
tor with the discharged battery.
⑤
After the engine is started, discon-
nect the negative cable rst. Then,
disconnect the positive cable.
⑥
Charge the discharged battery
for approx. 30 minutes after the
engine is started.
Make sure to connect the positive
terminal rst and connect the neg-
ative terminal to the engine body
of the tractor with the discharged
battery.
•
WARNING
CHECKING ELECTRIC WIRING
(1) Loo s e w i ri n g te r mi n al s ca n
cause contact failure and dam-
aged wirings can lead to per-
formance deterioration of elec-
tric devices, short circuit and
re. Replace or repair aged and
damaged wirings.
(2) If wiring sheath is peeled off,
wrap wiring with insulating plas-
tic tape.
(3) If fasteners or bands to fix wir-
ings are damaged, fix wirings
with clamps.
(4) Have wirings checked by your
workshop once a year regularly
to avoid re.
►