Negative
(-) terminal
(Black)
Positive (+)
terminal
(Red)
993F026A
< Checking >
①
Checking battery charging level
If the battery is not used for over
two weeks, it may become hard
to start the engine. Charge the
battery in this case.
The exact charging level can be
measured with a hydrometer or
through a certain test.
②
Check that the electrolyte level
is between the upper and lower
limits. If insufcient, add battery
acid to the upper level.
③
If the battery terminal is cor
-
roded, it cannot deliver current.
If it is corroded or contaminat-
ed, wipe it with sandpaper or a
brush.
•
•
< Charging >
①
Turn the ignition switch to the
"OFF" position and remove the
battery from the tractor.
②
Charge the battery in a well-ven
-
tilated area.
③
Charge the battery with the nor
-
mal procedures and avoid quick
charging.
④
Open the electrolyte ller hole of
the battery.
⑤
Turn the battery switch OFF and
connect the cables to the neg
-
ative and positive battery termi-
nals correctly.
⑥
When using a charger, its charg
-
ing current should be below 10 A.
To Next Page
Loading...
Need help?
General
