J10O342A
①
J10O340A
J10O341A
Towing hitch
Lift rod
mounting hole
When no implement is attached,
x the lower links with the left and
right check links so that they do
not touch the rear wheels.
Engage the top link with the hook.
•
•
NOTE
Make sure to use the towing hitch
for towing to avoid rollover. Nev-
er tow anything by connecting a
rope to the top link bracket, axle or
safety frame.
When using a rotavator that draws
power through the universal joint
from the PTO shaft, remove the
towing hitch from the tractor. Oth-
erwise, the universal joint hits and
damages the towing hitch, leading
to an accident.
•
•
WARNING
LOWER LINK
An implement can be attached to this.
The installation type is Category Il.
(Implement mounting hole diameter:
25.4
㎜
)
► TOWING HITCH
Install only an implement applicable
to this tractor.
► DRAWBAR ADJUSTMENT
Adjust the drawbar as follows:
Use the xing pin (1) to prevent
any lateral sway.
To adjust the distance between
the PTO and drawbar, move the
xing pin to another hole in the
drawbar.
►
•
•
To Next Page
Loading...
Need help?
General
