Upper limit
Lower limit
J10O515A
Do not add front axle oil over the
upper limit level.
Check the front axle oil before
starting the engine or at least
in 5 minutes after the engine is
stopped.
When trying to use new uid from
a different manufacturer or fluid
with different viscosity, drain used
fluid completely before adding
new uid.
•
•
•
NOTE
(3) Oil specication
Gear oil SAE 90W
(API GL-4 grade or higher)
If oil gets on your skin, it can ir-
ritate the skin and cause a skin
condition. Make sure to clean
your skin with soap and water or
hand cleaner thoroughly.
•
CAUTION
①
Make sure that the amount of
fuel in the fuel tank is sufcient.
Avoid to run the start motor for
over 5 consecutive seconds, but
run it several times at shorter in-
tervals.
•
CAUTION
②
If air is mixed in the pre-filter or
main filter, unscrew its bleeding
bolt (2), shown in the gure, and
turn the main switch to run the
start motor. Then, air in the fuel
lter is bled through the bleeding
bolt as shown in the gure above.
If lling the port with fuel before in-
stalling the fuel port, it is not neces-
sary to bleed the lter.
NOTE