THE ERROR CODE IS DISPLAYED THROUGH THE INDICATOR ON THE METER PANEL SIMULTANEOUSLY.
Error codes are displayed for 3P device and other devices' failure.
Find the cause and take any necessary action.
►
Fault code Description
11
Indicates Circuit Fault of the Lift Arm solenoid for Raising
12
Indicates Circuit Fault of the Lift Arm solenoid for Lowering
13
Indicates Short Fault of the Lift Solenoid for Raising/Lowering
14
Indicates Connecting Fault of the Exterior (raise and Lower) control button for Raising
15
Indicates Connecting Fault of the Exterior (raise and Lower) Control Button for Lowering
16
Indicate Power Supply Fault of the Lift Arm Controller (In short Circuit to +10V)
17
Indicate Power Supply Fault of the Lift Arm Controller (In short Circuit over +16V)
22
Indicates Position Sensor Fault
31
Indicates Right Daft Sensor Fault
32
Indicates Left Daft Sensor Fault
1301
Pressure too low at Hydraulic Clutch
1402
Short or Connecting fault at 4WD drive Solenoid
1403
Short or Connecting fault at Power shift (High/Low speed) Solenoid
1405
Short or Connecting fault at Forward Drive Terminal Solenoid
1406
Short or Connecting fault at Reverse Drive Terminal Solenoid
2301
Short or Connecting fault at Shuttle S/W
2302
Short or Connecting fault at strainer
To Next Page
Loading...
Need help?
General
