Chapter 3 LED Display Control Setting
24
2. Automatic Adjustment
Schedule, Auto, and Auto Adjustment by Hardware are automatic adjustment
modes. Automatic adjustment function is not recommended for indoor LED display
products because the indoor environment has stable ambient light and is rarely
affected by the ambient brightness. If you really need to use this function, you can
configure this function by using the wizard.
3.5 Correction Coefficient Management
The UpadIV series products have been subject to correction before shipment. To
ensure the optimum displaying effect of the screen, you need to activate the correction
function when using the LED display, and to reload the correction coefficients after
replacing the modules or receiving card. This Section introduces how to upload the
correction coefficients after replacing the modules or receiving card.
On the main window, click Calibration, as shown in Figure 3-13, to display the screen
calibration interface:
Figure 3-13 Main Window for Advanced User
To Next Page
Loading...
Need help?
General
