VIRDI 4000
TM
User’s Manual
32
UNION COMMUNITY Co., Ltd. 44-3 Hyundai Topics Building, Bangi-dong,
Songpa-gu, Seoul, Korea 138-050, Tel: 82-2-6488-3000, Fax: 82-2-6488-3099,
E-Mail:sales@unioncomm.co.kr, http://www.unioncomm.co.kr/eng
each mode can be used flexibly. If there are more than 10 terminals connected
to the server for simultaneous authentication, or there are frequent network
problems, it is recommended to use “SN” authentication (setting ‘1’).
Press [ENTER] to move to the next setting.
3.4.3. Connection method settings
◆ [*] [2] [ENTER] [ENTER] ◆
Network Type:0
0:Static 1:DHCP
Press [0] for Static IP.
Press [1] for DHCP.
The default is ‘0’ (Static IP). If a static IP is assigned to the terminal from present
network system, press [0]. If there is a DHCP server in network system from
which a dynamic IP is assigned to the terminal, press [1].
Press [ENTER] to move to the next setting.
※ For Static IP settings, refer to ‘3.4.4. IP address’, ‘3.4.5. Subnet mask’ and
‘3.4.6. Gateway’. For dynamic IP, there’s no need for additional settings.
3.4.4. IP address settings
< IP Address >
192.168. 0. 3
Press [#] to delete an old IP and enter the new
IP.
If the IP address is ‘210.98.100.50’, enter as below:
[2] [1] [0] [9] [8] [*] [1] [0] [0] [5] [0]
Press [ENTER] to move to the next setting.
3.4.5. Subnet mask settings
<Subnet Mask>
255.255.255. 0
Press [#] to delete an old value and enter the
new value.
If the subnet mask is ‘255.255.255.0’, enter as below:
[2] [5] [5] [2] [5] [5] [2] [5] [5] [0]
Press [ENTER] to move to the next setting.