VIRDI 4000
TM
User’s Manual
45
UNION COMMUNITY Co., Ltd. 44-3 Hyundai Topics Building, Bangi-dong,
Songpa-gu, Seoul, Korea 138-050, Tel: 82-2-6488-3000, Fax: 82-2-6488-3099,
E-Mail:sales@unioncomm.co.kr, http://www.unioncomm.co.kr/eng
This is to enable or disable the function keys. ‘O’ means enabling the function
key and ‘X’ means disabling the function key. Whenever the number conforming
to a function key in this setting is pressed, the setting is changed from ‘O’ to ‘X’.
In this setting, 1 is for [F1], 2 is for [F2], 3 is for [F3] and 4 is for [F4]. For
example, if an administrator presses [1] once in this setting the [F1] key is
disabled - [X], a user cannot enter into start mode by pressing the [F1] key
button as the [F1] key is now disabled.
Additionally, if only [F1] or [F2] is set to ‘O’, the terminal can be used in either
always start or always leave mode.
6 is used for setting detection function for fake fingerprints.
After the setting is complete, press [ENTER] to move to the upper menu.
3.8.2. Card reader settings
3.8.2.1. Card reader type setting
◆ [*] [6] ‘084265’ [ENTER] ◆[2]
Card Reader:0
0=Non 1=RF 2=SC
3=Wiegand 4=SC1
5=Ext
Default setting: ‘0’
This is to set the card reader mounted in a terminal. Refer to the followings for
correct setting:
- ‘0’: No card reader
- ‘1’: Low-frequency RF Card reader mounted
- ‘2’: High-frequency smart card reader
- ‘3’: Wiegand card reader, such as HID card module
- ‘4’: Other smart RF reader
- ‘5’: External card reader
If a card reader is mounted within a terminal and the above setting is correctly
done, when [F1]~[F4] or [ENTER] is pressed, the authentication mode is
changed and 1:1 fingerprint authentication is ready for operation - in this case,
1:N fingerprint authentication is not performed except for the auto sensing
setting.
After the setting is complete, press [ENTER] to move to the upper menu.
To Next Page
Loading...
Need help?
General
